[{"data":1,"prerenderedAt":27},["ShallowReactive",2],{"content-depth-of-field-en":3},{"about":4,"steps":7,"faq":11},[5,6],"Depth of field is the zone in front of and behind the focus point that still looks sharp in the final image. It depends on focal length, aperture, distance and the circle of confusion – how large a blur spot on the sensor may be without being noticed. The calculator shows the near and far limit, the total depth of field and how much of it lies in front of and behind the subject.","It also calculates the hyperfocal distance: focus there and sharpness reaches from half that distance to infinity – ideal for landscapes. The circle of confusion is the sensor diagonal divided by 1442 (0.030 mm on full frame); for higher demands you can set it yourself.",[8,9,10],"Pick your sensor format or enter custom sensor dimensions.","Enter the real focal length, the aperture and the distance to the subject.","Read the near limit, far limit and hyperfocal distance; the table shows the depth of field for every f-stop at this distance.",[12,15,18,21,24],{"q":13,"a":14},"What is the hyperfocal distance?","The shortest focus distance at which the far limit just reaches infinity. At 24 mm and f\u002F11 on full frame it is about 1.8 m – focused there, everything from about 0.9 m is sharp.",{"q":16,"a":17},"Why do small sensors have more depth of field?","For the same framing they need a shorter focal length, and depth of field grows quickly with shorter focal lengths. The permissible circle of confusion is smaller too, but overall more depth of field remains. The [[crop-factor]] shows how the focal lengths relate.",{"q":19,"a":20},"Which circle of confusion should I use?","The default (diagonal \u002F 1442) applies to a print of about 8 × 12 in viewed from a normal distance. For large prints or 100 % viewing on screen, half that value is more realistic – the depth of field then becomes much shallower.",{"q":22,"a":23},"Does the calculation work for macro?","Approximately. At close range, internal focusing and the pupil magnification change the effective focal length and aperture; depth of field is often only a few millimetres. For macros at 1:1 and beyond, focus stacking is usually the better way.",{"q":25,"a":26},"Do I enter the equivalent focal length?","No, always the real focal length printed on the lens. The calculator accounts for the sensor format through the circle of confusion. For smartphones you find the real focal length in the EXIF data, e.g. with the [[exif-viewer]].",1794509134462]