[{"data":1,"prerenderedAt":27},["ShallowReactive",2],{"content-pcb-trace-width-en":3},{"about":4,"steps":7,"faq":11},[5,6],"How wide must a trace be for 2 A? The calculator uses the IPC-2221 formula: I = k · ΔT^0.44 · A^0.725, with the cross-section A in mil² and k = 0.048 for outer layers or 0.024 for inner layers. From current, copper thickness and allowed temperature rise it gives the minimum width – or, the other way round, the maximum current for a width.","With a length it also shows the trace’s resistance, voltage drop and power loss, using the resistivity of copper at ambient temperature plus the rise. Copper thicknesses from 0.5 to 3 oz are available as presets.",[8,9,10],"Choose “Current → width” or “Width → current” and enter the current or the width in mm.","Set the copper thickness (usually 35 µm = 1 oz), the allowed temperature rise (often 10 K) and the layer.","Optionally enter the trace length to see resistance, voltage drop and power loss.",[12,15,18,21,24],{"q":13,"a":14},"Why do inner layers need wider traces?","Inner layers shed heat less well because they are surrounded by base material. IPC-2221 therefore halves the factor k; for the same current and rise an inner layer needs about 2.6 times the cross-section.",{"q":16,"a":17},"What does 1 oz copper mean?","1 oz\u002Fft² of copper is the amount that, rolled out over one square foot, is about 35 µm (1.37 mil) thick. Standard boards mostly use 35 µm; for high currents there is 70 µm (2 oz) and more.",{"q":19,"a":20},"Which temperature rise should I choose?","10 K is a common, cautious value. A higher rise allows narrower traces, but the trace must not reach the permitted temperature of the base material (around 130 °C for most FR4), and nearby parts heat up too.",{"q":22,"a":23},"How accurate is IPC-2221?","The formula is based on measurements from the 1950s and is usually conservative. The newer IPC-2152 takes board thickness, copper planes and mounting into account and often allows narrower traces. For wiring off the board there is the [[cable-voltage-drop]] calculator.",{"q":25,"a":26},"How much power is lost in the trace?","With a length the calculator shows P = I² · R. Calculate voltage, current and resistance in general with the [[ohms-law]] calculator.",1794509136418]