[{"data":1,"prerenderedAt":27},["ShallowReactive",2],{"content-rc-lc-filter-en":3},{"about":4,"steps":7,"faq":11},[5,6],"An RC network of a resistor and a capacitor is the simplest filter: as a low-pass it lets low frequencies through, as a high-pass the high ones. At the cutoff frequency fc = 1 \u002F (2π · R · C) the signal is attenuated by 3 dB; beyond it, it falls by 20 dB per decade. An RL network behaves the same with fc = R \u002F (2π · L).","An LC tank of a coil and a capacitor resonates at f0 = 1 \u002F (2π · √(L · C)). The calculator solves each formula for the missing value, shows the time constant or characteristic impedance and, for RC and RL networks, the frequency response with gain and phase at any frequency.",[8,9,10],"Choose RC, RL or LC.","Fill in two of the three fields, for example R = 1k and C = 100n; the third is calculated.","Choose low-pass or high-pass and optionally enter a frequency to read gain and phase there.",[12,15,18,21,24],{"q":13,"a":14},"How do I calculate the cutoff frequency of an RC filter?","With fc = 1 \u002F (2π · R · C). For 1 kΩ and 100 nF that is about 1.59 kHz. The calculator also solves the formula for R or C when you enter the desired cutoff frequency.",{"q":16,"a":17},"What is the time constant τ?","τ = R · C (or L \u002F R) tells how fast an RC network responds to a step: after τ the capacitor is charged to about 63 %, after 5 τ to over 99 %. Cutoff frequency and time constant are linked by fc = 1 \u002F (2π · τ).",{"q":19,"a":20},"Why −3 dB at the cutoff frequency?","There reactance and resistance are equal; the voltage drops to 1\u002F√2 ≈ 70.7 %, the power to half. The phase is −45° for the low-pass and +45° for the high-pass.",{"q":22,"a":23},"What does the characteristic impedance of a tank circuit tell me?","√(L\u002FC) is the reactance of the coil and the capacitor at resonance. Together with the loss resistance it determines the quality factor. For antennas and matching networks there is the [[impedance-matching]] calculator.",{"q":25,"a":26},"Which parts should I use?","Find the nearest standard value for the calculated R or C with the [[e-series-finder]]; the [[capacitor-code]] reads a capacitor’s marking.",1794509136847]