About this tool
ND (neutral density) filters block light without changing colours. They let you use long exposures in daylight – for silky water, streaking clouds or empty squares. The calculator extends your metered shutter speed by the filter strength; stacked filters such as ND8 + ND1000 are added up automatically.
Manufacturers label filters differently: as a factor (ND1000), as optical density (3.0) or in stops (10 stops). The calculator understands all three and also works backwards: for a target time of, say, 30 seconds it shows the filter strength you need. A timer counts down long exposures in bulb mode.
How it works
- Meter without the filter and enter the shutter speed, e.g. 1/125.
- Pick the filters you use or type them in (e.g. ND8 + ND1000) – or switch to “Time → filter” and enter the desired time.
- Read the new shutter speed and start the timer for bulb mode if needed.
Frequently asked questions
What do ND8, ND64 and ND1000 mean?
The number is the filter factor: an ND8 passes 1/8 of the light, which is 3 stops; ND64 is 6 and ND1000 about 10 stops (exactly it would be 1024). The optical density is 0.3 per stop, so an ND1000 is also called ND 3.0.
How do I calculate stacked filters?
Stops add up, factors multiply: ND8 + ND1000 make 13 stops or a factor of 8192. Just enter both filters and the calculator adds them.
Why is my image still too bright or too dark?
Strong filters often deviate by a third to half a stop from their rating, and the light changes during long exposures. Check the histogram of the first frame and adjust the time. On film, reciprocity failure adds to this – the Exposure & Reciprocity Calculator accounts for it.
What about times longer than 30 seconds?
Most cameras only offer automatic times up to 30 s. For longer exposures switch to bulb mode, use a remote release and start the timer here. For series of long exposures, the Interval Timer helps too.