Resistor Color Code

Read resistor color bands or find the bands for a value – 3, 4, 5 and 6 bands after IEC 60062, with tolerance, temperature coefficient and E series.

Runs locally in your browser
Bands
4.7 kΩ ±5 %
Resistance4.7 kΩ
Tolerance±5 %
Range4.465 kΩ … 4.935 kΩ
E seriesE3

Read from the side whose band is closer to the end; the tolerance band (often gold or silver) usually sits a little apart on the right.

About this tool

Through-hole resistors show their value as colored bands. The calculator translates the bands into ohms, tolerance and – with a sixth band – the temperature coefficient, and turns a value such as 4k7 into the matching colors. It also shows the range the real resistance may lie in and the smallest E series the value belongs to.

With 4 bands the first two are digits, the third is the multiplier (power of ten) and the fourth the tolerance. With 5 and 6 bands there are three digits; the sixth band is the temperature coefficient. A resistor with only 3 bands has no tolerance band and thus ±20 %. The colors follow IEC 60062:2016.

How it works

  1. Choose “Colors → value” and set the number of bands.
  2. Pick the color of each band from left to right; value, tolerance and range appear right away.
  3. Under “Value → colors” enter a value such as 4k7, 220 or 1M and get the bands for 4, 5 or 6 bands.

Frequently asked questions

Which side do I read from?

The tolerance band (often gold or silver) usually sits a little apart at the right end; read from the other side. Gold and silver are never the first band. If one direction gives a value that is not in any E series, the other one is usually right.

What do gold and silver mean as third or fourth band?

As a multiplier gold means ×0.1 and silver ×0.01 – this is how values below 10 Ω are marked, e.g. yellow-violet-gold for 4.7 Ω. As the tolerance band they stand for ±5 % and ±10 %.

Why does grey show ±0.01 %?

Since IEC 60062:2016 grey stands for ±0.01 %, orange for ±0.05 % and yellow for ±0.02 %. Older precision resistors sometimes still use grey for ±0.05 %, and some high-voltage resistors use yellow and grey instead of gold and silver.

What is the E series?

Resistors only come in standardized values, the E series (E6, E12, E24, E96 …). The finer the series, the tighter the tolerance. Find the nearest standard value for any value with the E Series Finder.

Which resistor do I need for my LED?

The LED Resistor Calculator calculates it. The relations between voltage, current, resistance and power are shown by the Ohm’s Law Calculator calculator.