About this tool
The NE555 is one of the best-known ICs of all: with two resistors and a capacitor it becomes a clock generator (astable multivibrator), with one resistor and a capacitor a timer that outputs a pulse of fixed length after a trigger (monostable multivibrator).
The calculator works out frequency, period, high and low time and duty cycle of the oscillator, and the pulse length of the monostable circuit. In “Design” mode it works backwards: from the desired frequency and duty cycle, or pulse length, and the capacitor it finds the resistors, rounded to the chosen E series.
How it works
- Choose astable (oscillator) or monostable (single pulse) and whether you want to calculate or design a circuit.
- Enter R1, R2 and C – or frequency, duty cycle and C. Values such as 10k, 100n or 4µ7 work.
- Read frequency, times and duty cycle; when designing, also the standard values and the exact resistances.
Frequently asked questions
How do you calculate the frequency of a 555?
In the basic astable circuit C charges through R1 + R2 and discharges through R2, each time between 1/3 and 2/3 of the supply. That gives high time = ln 2 · (R1 + R2) · C and low time = ln 2 · R2 · C, together f ≈ 1.44 / ((R1 + 2·R2) · C). The supply voltage cancels out.
Why can the duty cycle not go below 50 %?
Because C charges through R1 + R2 but discharges only through R2, the high time is always longer. With a diode across R2, C charges through R1 only, which allows values below 50 % – the calculator does not model that.
How long is the pulse in monostable mode?
t = ln 3 · R · C ≈ 1.1 · R · C. With 100 kΩ and 10 µF that is about 1.1 seconds. For long times a large resistor is better than a large electrolytic capacitor, because electrolytics have high tolerances and leakage.
Which components make sense?
R1 should be about 1 kΩ or more, the resistors not above a few MΩ. Film or C0G ceramic capacitors give stable frequencies. The Capacitor Code Calculator reads a capacitor’s marking, the E Series Finder shows standard values.