SMD Resistor Code Calculator

Decode SMD resistor markings – 3-digit (472), 4-digit (4702), R notation (4R7) and EIA-96 (01C) – or find the marking for a value.

Runs locally in your browser
Examples
Resistance
4.7 kΩ
Marking system3 digits: two digits plus the number of zeros
Typical tolerance±5 %
E seriesE3

Value → marking

Ω
3-digit103
4-digit1002
EIA-9601C

EIA-96 multipliers

Z ×0.001Y ×0.01X ×0.1A ×1B ×10C ×100D ×1,000E ×10,000F ×100,000

About this tool

SMD resistors carry a short marking instead of color bands. With 3 digits the first two are the value and the third is the number of zeros (472 = 4700 Ω); with 4 digits there are three value digits (4702 = 47 kΩ). An R stands for the decimal point (4R7 = 4.7 Ω), 000 for a zero-ohm jumper.

Precision ±1 % resistors in small packages often use the EIA-96 code: two digits as an index into the E96 series and a letter as the multiplier, e.g. 01C = 100 · 100 = 10 kΩ. The calculator recognizes all of these and shows the other way round how a value is marked.

How it works

  1. Type the marking, for example 472, 4702, 4R7 or 01C; upper or lower case does not matter.
  2. Read the resistance, the recognized marking system and the typical tolerance.
  3. Under “Value → marking” see how a value such as 10k looks as a 3-digit, 4-digit and EIA-96 code.

Frequently asked questions

What does 103 on an SMD resistor mean?

10 and three zeros = 10,000 Ω = 10 kΩ. Likewise 101 = 100 Ω, 472 = 4.7 kΩ and 105 = 1 MΩ. Note: on capacitors the same code means picofarads – use the Capacitor Code Calculator for those.

How do I recognize EIA-96?

EIA-96 always has two digits and a letter, e.g. 01C or 68X. The digits 01 to 96 count through the E96 series (01 = 100, 02 = 102 … 96 = 976), the letter is the multiplier: Z ×0.001, Y/R ×0.01, X/S ×0.1, A ×1, B/H ×10, C ×100, D ×1000, E ×10,000, F ×100,000.

What tolerance does the resistor have?

The marking does not encode the tolerance directly. ±5 % is common for 3-digit codes and ±1 % for 4-digit and EIA-96 codes, so the calculator only shows a typical value. The datasheet or the reel label is binding.

Why do some resistors have no marking at all?

Packages such as 0402 and smaller are too small for a marking. Then only measuring or the reel label helps. Find the nearest standard value for a measured value with the E Series Finder.

How do I read through-hole resistors?

By their color bands – the Resistor Color Code handles that.