Voltage Divider Calculator

Output voltage of a resistor divider – or the best pair of standard resistors (E12, E24, E96 …) for a target voltage, with current, power and load.

Runs locally in your browser
VinR1R2Vout
V
Ω
Ω
Ω
Output voltage
3.367 V
Ratio0.2806
Current863.3 µA
Power in R17.453 mW
Power in R22.907 mW
Output resistance2.806 kΩ

About this tool

A voltage divider made of two resistors steps a voltage down: Vout = Vin · R2 / (R1 + R2). The calculator shows the output voltage, the divider current, the power in both resistors and the output resistance – optionally with a load parallel to R2, such as an ADC input.

In “Find resistors” mode you enter the input and target voltage, and the calculator searches the best pair of standard values from the chosen E series. The approximate total resistance controls how much current the divider may draw.

How it works

  1. Choose “Output voltage” to check an existing divider, or “Find resistors” to design one.
  2. Enter the input voltage and R1 (top) and R2 (bottom) – or the target voltage, the E series and the approximate total resistance. Values like 10k or 3k9 work.
  3. Optionally enter the load at the output. Clicking a pair found by the search opens it in the detailed calculation.

Frequently asked questions

How large should the resistors be?

Small resistors draw a lot of current and waste power, large ones make the output high-impedance and sensitive to load and noise. For microcontroller measurement inputs 10–100 kΩ in total are common; if a load is connected, it should be at least ten times larger than R2.

Why is the voltage off under load?

A load sits parallel to R2 and so reduces the bottom resistance – the output voltage drops. Enter the load and the calculator includes it, also when searching for standard values. A divider is not suitable as a power supply for loads; that is what a voltage regulator is for.

Is a finer E series always more accurate?

Usually, but not always. The values of E48, E96 and E192 are spaced evenly on a log scale, so only certain ratios of R2 to R1 exist. The historically rounded values of E12 and E24 hit some ratios better by chance. The calculator shows the deviation of every solution.

Can I use a divider to step 5 V down to 3.3 V for a microcontroller?

For signals going one way (e.g. a 5 V output to a 3.3 V input), yes – e.g. with 1.8 kΩ and 3.3 kΩ. For fast or bidirectional signals such as I²C a level shifter is better.

How do I find a single standard value?

With the E Series Finder. Voltage, current and power at a single resistor are calculated by the Ohm’s Law Calculator calculator.